Sunday, 8 April 2012

TaylorMade R11 Driver sale

The R11 Driver Flight Control Technology (FCT) allows you to increase or decrease the launch angle by one degree. There are eight different FCT positions that allow you to increase or decrease the loft in .5 degree increments and with every adjustment comes a change in the face angle as well as the spin rate.


The standard shaft in the R11 is the Fujikura Blur 60 gram shaft, available in X, S, R and M flexes. The 360° graphics mean the visuals look the same regardless of the position of the shaft. 
Because of the flight control technology on offer the TaylorMade R11 Driver sale is only available in 9° or 10.5° models. However, these heads can then be set 1° higher, 1° lower or 0.5° up or down. 

The TaylorMade R11 Driver comes equipped with Movable Weight Technology (MWT), which allows you to tune the driver’s center of gravity to promote a draw or neutral ball flight. With the 10g weight in the heel and the 1g weight in the toe, you’ll get more of a draw bias ball flight. With the 1g weight in the heel and the 10g weight in the toe, R11 generates a more neutral ball flight.
Movable weight affects the left-to-right flight, while unscrewing and resetting the shaft into the head sets the loft. A new adjustable sole plate adds a third custom option to the head. The face angle and loft can be adjusted independently. A section of the sole is unscrewed and reset (open, closed or neutral) to change the position of the face at address.


No comments:

Post a Comment